Carpet Mill Plans

[Infidel77]

I've seen on here and other forums, where people were asking about how to build a carpet mill. I've built several and took photos to show how easy it is to build your own. For the frame I used 2x4 cut to 60". The inside frame supports are cut to 24" and then using a Kreig Jig, I drilled pocket holes to give a strong, tight joint. The rollers are 23 3/4" conveyor rollers in 2" dia I picked up off eBay. I then placed a 1/2" 40"x24" plywood sheet on top of the supports with a sheet of shower board on top of that to help the carpet glide. The front leg is 18" with a 30 deg angle cut in, and the rears are 8" with a 15 deg angle. I then built vertical supports 30" tall and screwed in eyelets to hook to the harness.